Triplett 2000 Manual do Utilizador descarregar pdf (Página 15)

Page 15

3.6 Battery and Fuse Test

Before using the Test Set, and frequently during use, the batteries

and fuses in the Test Set should be tested. Refer to Section 3.7 for

instructions on installing and/or replacing the batteries and fuses if

necessary.

3.6.1 9V Battery Test

Place the Test Set Range Switch in the OFF position. Depress and

hold the Push For Ohms Switch. The Pointer will deflect upscale

and the red NEG Indicator will light. If the Pointer fails to deflect into

the blue BATT OK scale, then both 9V batteries must be replaced.

Replace the batteries if necessary, then repeat this test. Proceed to

the Fuse Test (Section 3.6.2) only after successfully passing this test.

3.6.2 Fuse Test

The Test Set contains two fuses. Both must be tested and found

good for safe operation of the instrument.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Sem comentários

Triplett 2000 Manual do Utilizador Página 15