Triplett 9007 Manual do Utilizador descarregar pdf (Página 34)

Page 33

7.8 Continuity Beeper:

WARNING!

Do not apply voltage or current to the meter when it is set

to the Diode Test / Continuity Beeper “ ” range.

7.8.1 Connect the black test lead to the COM jack and the red test

lead to the VOLT / DIODE / OHM / CAP “V Ω CAP” jack.

7.8.2 Set the RANGE switch to the Diode Test / Continuity Beeper

“ ” range.

7.8.3 Connect the test probes to the device or circuit to be tested.

7.8.4 If the resistance of the device or circuit is less than 20 to 100

Ohms, the continuity beeper will sound.

Note:ThereadingdisplayedontheLCDisnotanaccurateindicationof

theresistanceofthedeviceorcircuitbeingmeasured.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 47 48

Sem comentários

Triplett 9007 Manual do Utilizador Página 34