Triplett 9007 Manual do Utilizador descarregar pdf (Página 37)

Page 36

7.10.5 If the displayed value is less than “200” (decimal point not

shown), a more accurate reading may be obtained by setting

the RANGE switch to a lower range. Rotate the RANGE switch

to the next lower position and observe the reading on the LCD

display. If the RANGE switch is already on the lowest position

(i.e. 2n F), no greater measurement resolution can be obtained.

Notes:

a)Onthe2nFand20nFranges,themetermayindicateresidual

capacitance.i.eThemeterreadingwillnotgotozero.Thisis

causedbytheinternalcapacitanceofthemetercircuitryorthe

testleads.

b)TheTestLeadsmayintroduceerrorwhenusedonthelow

capacitanceranges(like2nFand20nF).Tominimizetheerror,

notethedifferenceinreadingwiththeleadsinsertedintothe

meterandwiththeleadsremovedfromthemeter,andwhen

usingthetestleads,subtractthenoteddifferencefromthe

displayedreading.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 47 48

Sem comentários

Triplett 9007 Manual do Utilizador Página 37