Triplett CamView PTZ – PN: 8000 Manual do Utilizador descarregar pdf (Página 24)

A. Connecting the CamView to an RS-485 PTZ Camera:

Connect the video signal from the PTZ camera to the VIDEO IN jack of the

CamView. This is usually accomplished with a coaxial cable with BNC connec-

tors. Sometimes, the camera uses a dierent connection (because BNC’s are

too large). Connect the PTZ wires from the camera to the RS-485 jack of the

CamView using the provided PTZ test cable.

B. Setting the Communication Port:

With the CamView in the ‘PTZ controller’ mode, press to access the PTZ

settings. Then press or to move the cursor to “Port”, and select

‘RS485’ by pressing or as required. Press to save the setting.

Press to exit.

C. Setting the Address

With the CamView in the ‘PTZ controller’ mode, press to access the PTZ

settings. Then press or to move the cursor to “Address”, and set

the address to match the camera address by pressing or as required.

Press to save the setting. Press to exit.

D. Setting the Protocol

With the CamView in the ‘PTZ controller’ mode, press to access the PTZ

settings. Then press or to move the cursor to “Protocol”, and select

the camera’s PTZ protocol by pressing or as required. Press to

save the setting. Press to exit.

E. Setting the Bit Rate

With the CamView in the ‘PTZ controller’ mode, press to access the PTZ

settings. Then press or to move the cursor to “Baud”, and set the

baud rate to match the camera by pressing or as required. Press

to save the setting. Press to exit.

Page 22

3.3.2 Setting PTZ Parameters (Details) Cont.

SET

RETURN

SET

RETURN

SET

RETURN

SET

RETURN

ENTER

OPEN

ENTER

OPEN

ENTER

OPEN

ENTER

OPEN

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Comentários a estes Manuais

Sem comentários

Triplett CamView PTZ – PN: 8000 Manual do Utilizador Página 24

Comentários a estes Manuais

Manuais e produtos relacionados com Instrumentos de medida Triplett CamView PTZ – PN: 8000