Triplett CamView PTZ – PN: 8000 Manual do Utilizador descarregar pdf (Página 35)

Page 33

This feature is intended to preserve the charge on the battery if the prod-

uct is unused for some period of time. The ‘Auto power o’ feature can be

Disabled if desired.

Use or to move the cursor to ‘Auto power o’. Then use or to

select the desired ‘time-out’ interval. Select ‘Disabled’ to allow the CamView

to run continuously. ‘Apply’ the change by pressing .

3.8.2 Keypad tone

The ‘Key Beep’ can be turned on or o.

Use or to move the cursor to ‘Prompt sound’. Then select ‘O’ or ‘On’

using the or buttons. ‘Apply’ the change by pressing .

3.8.3 Language

English or Chinese can be selected as the operational language for the

CamView. Use or to move the cursor to ‘Language’. Then select

‘English’ or ‘Chinese Symbols’ using the and buttons. ‘Apply’ the

change by pressing .

3.8.4 Brightness

The brightness of the menus can be set as desired.

Use or to move the cursor to ‘Brightness’. Then select a brightness

from 0 to 7 using the and buttons. ‘Apply’ the change by pressing

ENTER

OPEN

ENTER

OPEN

ENTER

OPEN

ENTER

OPEN

3.8.5 Automatic Address Search

The CamView PTZ makes it easy to nd the address of a PTZ controlled cam-

era. The PTZ Protocol and Baud Rate must be known to use this feature. This

is usually not a problem because installers often use the same protocol and

baud rate in all their installations.

is usually not a problem because installers often use the same protocol and

baud rate in all their installations.

The Address Search feature must be initialized each time the product is

turned on. If the product is turned o and back on, the feature must be

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 43 44

Sem comentários

Triplett CamView PTZ – PN: 8000 Manual do Utilizador Página 35